Technological procedure for mounting

Surface preparation

• The system components are to be installed only on dry and thoroughly cleaned surfaces free from pigeon droppings, grease, and dust at a temperature of 5°C or more.

Installation

The strips are to be placed parallel to the edge of the surface in a row, side by side. For the drainage of water from the area behind the strips, a 5mm gap should be left between the individual strips.

• Mounting using a silicone glue
• - For mounting using glue, we recommend Silirub 2® neutral transparent silicone glue by Soudal®.
• - The glue must be applied on the full length of the basic strip.
• - The strip with the silicone applied is to be lightly pressed onto the surface. Then we can check whether the strip is mounted in the required position.
• - The glue sets in 24 hours. After 10 minutes the glue produces a hard shell.
• - One cartridge of the glue can be used to mount 8m to 12m of the spike system, depending on the surface material.

• Mounting using nails
• - Nails are to be used for mounting onto wooden surfaces.
• - For the nails, the holes in the basic strips are to be used.

• Mounting using wood screws
• - Screws are to be used for mounting onto wooden surfaces.
• - For the screws, the holes in the basic strips are to be used.